Extraction unit for reflow oven HR-10 and HR-10-DO.
It sucks the soldering fumes only after the melting is finished.
Due to the forced air flow in the furnace, the cooling time is reduced.
The suction unit includes a fan and a switching unit.
Connects to prepared HR-10 / HR-10-DO furnace connectors.
The furnace control system controls the fan speed. During preheating and re-melting, the speed is minimal to prevent cold air being drawn into the furnace. cycle. Just after finishing the rewind before the door is opened, the fan speed is increased to a maximum for complete exhausting after soldering. The fan speed is again reduced to a minimum after the furnace has cooled to ground temperature.
The outlet from the suction unit can be connected either to the central suction inlet or to a separate filter unit.
Accessory Contents:
Power supply cable 230V / 50Hz - male for direct connection to HR-10 / HR-10-DO
Signal cable - fan speed control from the furnace control board
Inlet hose 1 m with a diameter of 50mm
Outlet hose 1 m with a diameter of 56 mm.
Never shorten these hoses for sufficient cooling of the exhaust fumes!